allplace@allplace.cn

+86-531-88919688

Product Categories
Contact KYORICHI

Address: A4-08 Cross-Border Industrial Park Fenghuangshan Road, Tianqiao District, Jinan City, Shandong, China(Mainland)

TEL: +86-531-88919688

Mob: +86-13905313508

Email: allplace@allplace.cn

Website: www.apuvcoating.com

Home > News > Content
Line Reinforcing Uv Glue (new) Jan 09, 2018

The detailed information


Features of 5806M products:

5806M is the highest intensity uv curing acrylate adhesive. For the PC material, PMMA material, PVC material, teflon material and ABS materials, PCB board adhesive has excellent stick relay, film good flexibility, high peel strength and curing effect is good, typically used in PVC, ABS and FPC board fixed and PCB wiring on bonding applications.


Typical curing properties:

5806M will solidify under ultraviolet light and slowly solidify under sunlight. Curing rate, final curing depth and table drying effect are related to uv light source, light time, material transmittance and other factors. It is suggested that specific curing time should be determined through experiments.

Location time:

PC material testing:

5 seconds -125W PHILIPS high voltage fluorescent lamp.

Full cure time:

90-120 seconds -125W PHILIPS high pressure fluorescent lamp.

Typical curing performance:

The tensile shear strength (GB 7124-86) is about 25 x 12 = 300 mm2.

PC/PC, PC 0.6 mm thick sheet of adhesive on the 5 mm thick PVC lining as specimen, the temperature of 25 ℃ :

The tensile shear strength >10MPa is all PC damage.

PVC/PVC, 3 m thick PVC as specimen, the temperature is 25 ℃.

The tensile shear strength of 14 MPa is damaged by PVC.

Instructions:

1. Clean the glue, and the adhesive surface must be dusted, degreased and dried, and the amount of glue should be determined according to the need.

2. Recommended minimum light intensity of 70mW/cm2.

3. Temperature sensitive materials such as thermoplastic materials need cooling devices.

4. Check the solidification of plastic material to prevent the liquid from producing stress cracks.

5. Excessive spillage can be wiped away.

6. Use the remaining glue to prevent contamination.

Notes:

Avoid contact with eyes, skin and clothing. This product has mild irritation to eyes and skin. If the eye drops accidentally, please rinse immediately with plenty of water. If there is any discomfort, please go to the hospital for inspection. Wash with soapy water immediately after skin contact. Please clean the clothes before you wear them. Keep out of reach of children.

Storage: this product is sensitive to heat and light, store in a cool, dry place, avoid light preservation, below 25 ℃, valid for one year.

Product key words: line reinforcing uv glue, uv glue, uv glue.